Fabric valances allow you to maintain your view while adding a decorative flair to your window. They can be used on their own, or as the perfect finishing compliment to your existing blinds or shades. Fabric Roll-Up valances are easy to install, in this short video you will see just how simple it is. After unpacking and inspecting your order, loosen the screws on the back of each wood bracket and remove the attached bracket holders. Next, take one of the finials and insert the screw on the finial into the pre-drilled hole at the end of the pole. Turn clockwise to secure the finial. Slide the other end of the wood pole through the opening in along the top edge of the valance. Attach the second finial to secure the valance fabric to your pole. Your valance may be hung above your window at any height that you prefer. Placing your valance higher will make your window look bigger and block less of your view. Place your valance at varying heights to determine what looks best for you. Measure 4" to the outside of your window opening and make a guide mark above your window at the height you have selected for your valance rod, then drill or tap starter holes through the center of your marks. Plastic wall anchors are included for attaching your mounting hardware. Simply tap the anchors into your starter holes and attach the bracket holders to both sides of your window with the included hardware. To mount your brackets to the wall, reattach them to their mounting hardware by sliding the screws in the brackets down on to the slots. Take your completed valance and carefully set the pole on your brackets. Fan valance to the inside edges of your bracket and complete your installation by adjusting the folds to a pleasing arrangement. And that’s it! If you still have any questions just give us a call, it’s that easy.