Sheer Horizontal Shades are easy to install, in this short video you will learn to install them. A screwdriver is all that’s needed to install your blinds; or for an easier installation you can use a cordless screwdriver or a drill with a ¼” Hex head bit. Before starting, carefully unpack your blinds and mounting hardware. To familiarize yourself with the contents of your box, check the printed instructions included with your product. Begin your installation by positioning your mounting brackets 2 1/2” in from each side of your window along the top of the window opening. Line up the front of each bracket so they are even. Mark where your screws will go by lightly tapping starter holes into the mounting surface through the slots in the bracket and then fastening the supplied screws for each one. Use any additional support bracket that may be included, the proper number of brackets will be included based on the width of your shade. To install the headrail, slide it onto your brackets and gently push until it is seated in the bracket. To complete your installation, install the cord tensioner near the inside bottom of your window frame where it will not interfere with the operation of your shade. Finish by lowering and testing your new shade. Pull the cord to lower your shade, and continue pulling the cord to lift your shade to the fully raised position. If you still have any questions about the installation of your shades just give us a call.