Outside Mount Woven Wood Shades are easy to install. In this short video, you will learn how to install them. Brought to you by Blinds.com.
<p>Woven Wood shades are easy to install, in this short video you will learn to install them. A screwdriver is all that’s needed to install your shades; or for an easier installation you can use a cordless screwdriver or a drill with a ¼” Hex head bit. Before starting, carefully unpack your shades and mounting hardware. To familiarize yourself with the contents of your box, check the printed instructions included with your product. </p> <p>Begin your installation by marking a line with a pencil along the width of the slots located at each end of the shade. Place your brackets along the bottom of your pencil mark and lightly tap starter holes with a hammer. Fasten each bracket with the supplied screws. Line up your bracket with the slots on the top of the shade. Push the headrail up onto the brackets so that the threaded posts on the bracket fit through the slots on the headrail. Lift up the valance and secure your shade using the enclosed wing nuts. Turn the wing nut until it is snug. Repeat on the right. Cover each end of your headrail by using the included side flaps. </p> <p>Finish by lowering and tesing your new shade. To lower your shade, pull the cord toward the center of your shade and slowly raise your hand while holding onto the cord. To raise your shade, pull the lift cord away from your shade at any angle. And that’s it! If you still have questions about the installation of your shades just give us a call, it’s that easy.</p>